Product ID:MIL-E-24635A BLACK 37038 PC L8-007
MSDS Date:06/23/1992
FSC:8010
NIIN:01-344-6703
MSDS Number: BPVLC

CRAWFORD LABS, INC

4165 S EMERALD AVE
CHICAGO, IL 60609
US

Emergency Phone: 312-433-1307

Info Phone: 312-376-7132

Preparer: DAVID SCHMETTERER

Cage: 5V430

CRAWFORD LABORATORIES, INC

CHICAGO, IL 60609 US

Telephone: 312-376-7132

Cage: 5V430

100 SOLVENT (VAPOR PRESSURE 9. MM HG)

CAS: 64742-95-6

Fraction By Weight: 25%

OSHA PEL 50 PPM

ACGIH TLV: 50 PPM

MAGNESIUM SILICATE HYDRATE (CONTAINS CRYSTALLINE SILICA AT

CAS: 14807-96-6

RTECS: WW2710000

Fraction By Weight: 15%

ACGIH TLV: 2 MG/M3

SILICON DIOXIDE (ABOVE INGREDIENT MAY BE RELEASED BY

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: 25%

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.1 MG/M3 RDUST;9293

MINERAL SPIRITS/66 (VAPOR PRESSURE 3.4 MM HG)

CAS: 8032-32-4

RTECS: OI6180000

Fraction By Weight: <5%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM

340 GPL.

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:UNKNOWN IARC:YES
Health Hazards Acute and Chronic:OVEREXPOSURE MAY PRODUCE VARIOUS
EFFECTS, INCLUDING: ACUTE TOXICITY (HEADACHE, DIZZINESS, NAUSEA,
LOSS OF CONSCIOUSNESS). SEVERE EYE IRRITATION, POSSIBLE PERMANENT
DAMAGE, IRRITATED MUCOUS MEMBRANES, VOMITING DUE TO INGESTION,
DEFATTING & DRYING OF SKIN (IRRITATION, DERMATITIS), SENSITIZATION
AFTER REPEATED CONTACT.
Explanation of Carcinogenicity:SILICA IS LISTED BY IARC AS A 2A
CARCINOGEN.
Effects of Overexposure:IF EXPOSED OT PAINT DUST DUE TO SANDING,
OVEREXPOSURE BY INHALATION CAUSES LUNG INJURY/DISEAS(SILICOSIS.)

First Aid:EYE:FLUSH W/WATER 15MIN HOLD EYELIDS OPEN.GET MED
AID.INHAL:REMOVE TO FRESH AIR.GIVE OXYGEN IF BREATH DIFFICULT.GIVE
ARTIF RESPIRATION IF NOT BREATH.GET MED AID.KEEP WARM,
COMFORTABLE.NEVER GIVE UNCON SCIOUS PERSON LIQS.INGEST:CALL DR
IMMEDIATELY.ONLY INDUCE VOMITING ON DR'S INSTRUCTIONS.IF VOMIT
OCCURS,KEEP HEAD BELOW HIPS(PREVENT ASPIRATION INTO
LUNGS.SKIN:FLUSH W/WATER,REMOVING CONTAM CLOTH, *

Flash Point Method:SCC
Flash Point:108F,42C
Lower Limits:0.9
Extinguishing Media:FOAM, CO2, OR DRY CHEMICAL
Fire Fighting Procedures:WATER MAY BE USED TO KEEP EXPOSED CNTNR COOL &
TO KEEP FLAMMABLE STRUCTURES WET. DONT ENTER FIRE AREA W/OUT PROPER
PROTECTION BECAUSE HZD DECOMP MAY BE PRESENT.
Unusual Fire/Explosion Hazard:WATER PRESSURE MAY SPREAD A COMBUSTIBLE
LIQUID FIRE. SEALED CONTAINERS MAY EXPLODE IF OVERHEATED.

Spill Release Procedures:WARNING-COMBUSTIBLE. ELIMINATE IGNITION
SOURCES. GROUND HANDLING EQUIP (PREVENT SPARKS). WEAR PROTECTIVE
CLOTHING (SEE CONTROL MEASURES). SOAK UP W/ABSORBENT & PLACE IN NON
LEAKING CONTAINER FOR PROPE R DISPOSAL. D001, IGNITABLE.

Handling and Storage Precautions:TREAT AS HAZARDOUS, COMBUSTIBLE
MATERIAL. STORE IN COOL, DRY PLACE IN BLDGS DESIGNED FOR STORAGE OF
COMBUSTIBLE LIQUIDS.
Other Precautions:WARNING: HOT ORGANIC CHEMICAL VAPOR/MIST SUSCEPTIBLE
TO SUDDEN SPONTANEOUS COMBUSTION WHEN MIXED W/AIR. IGNITION TEMPS
DECREASE WITH INCREASING VAPOR VOLUME & VAPOR/AIR CONTACT TIME &
ARE INFLUENCED B Y PRESSURE CHANGES. **

Respiratory Protection:USE NIOSH APPROVED ORGANIC VAPOR RESPIRATORS
WHERE VENTILATION IS INADEQUATE.
Ventilation:MUST PROVIDE ADEQUATE VENTILATION, SEE RESPIRATION
PROTECTION.
Protective Gloves:USE RUBBER GLOVES
Eye Protection:WEAR APPROVED SAFETY GOGGLES
Other Protective Equipment:HAVE EYE BATH & SAFETY SHOWER AVAILABLE.
Supplemental Safety and Health
** IGNITION MAY OCCUR AT TYPICAL ELEVATED TEMPERATURE PROCESS
CONDITIONS, ESPECIALLY IN PROCESS OPERATING UNDER VACUUM IF
SUBJECTED TO SUDDEN INGRESS OF AIR OR OUTSIDE PROCESS EQUIPMENT
UNDER ELEVATED PRESSURE IF SUDDEN ESCAPE OF VAPOR/MIST TO
ATMOSPHERE OCCURS. EVALUATE PROPOSED USE OF PROD IN ELEVATED TEMP
PROCESS.

HCC:F4
Boiling Pt:B.P. Text:308 TO 396F
Vapor Density:> AIR
Spec Gravity:1.28
Viscosity:90 KU
Evaporation Rate & Reference:0.17 X N-BUTYL ACETATE
Solubility in Water:SLIGHT
Appearance and Odor:BLACK LIQUID, SOLVENT ODOR
Percent Volatiles by Volume:39.6
Corrosion Rate:NOT CORR

Stability Indicator/Materials to Avoid:YES
MAY BE INCOMPATIBLE WITH STRONG OXIDIZING AGENTS AND STRONG ALKALIES.
Stability Condition to Avoid:AVOID HEAT, SPARKS, OPEN FLAMES, &
INCOMPATIBILITIES. ALSO AIRCRAFT TRANSPORT MUST BE IN STRICT ACCORD
W/REGULATIONS.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION FOR PRODUCTS
LIKE THIS MAY FORM HIGHLY POISONOUS CARBON MONOXIDE AND OTHER TOXIC
GASES.

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH CURRENT
LOCAL, STATE AND FEDERAL REGULATIONS. CONTACT AN APPROVED DISPOSAL
FACILITY.
*DONT REUSE CLOTHES/S HOES TILL CLEANED. IF IRRIT PERSISTS, GET MED
AID.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.